[. . . ] Repairs Repairs should only be performed by specialists using original spare parts. *Depending on model: it means special equipment for some models or optional accessories. RS-RT900034), suitable for textile bags* Your vacuum cleaner is equipped with either a microfilter* or an HEPA filter cassette*. BEFORE FIRST USE Unpacking Unpack your appliance, keep your guarantee form and read the instructions carefully before using your appliance for the first time. [. . . ] 903397-01_MO24_city-space_903397/01 10/07/13 09:32 Page9 • If your vacuum cleaner is equipped with a telescopic tube* (20) : push the clamping button forward, extend the tube to the desired length and release the button to lock the tube in place - fig. € Fit the required accessory onto the end of the tube: - For rugs and carpets: use the "all floors” nozzle (23) with the brush tucked in - fig. - For wood and hard floors: use the “all floors” nozzle (23) with the brush pulled out (fig. - For corners and hard to reach spots: use the crevice tool convertible into brush (26) in the flat position. - For upholstery and delicate surfaces: use the crevice tool convertible into brush (26) or the upholstery nozzle* (25). Always switch off and disconnect your vacuum cleaner before changing any accessories. EN Plugging and switching on the appliance • Unwind the power cord completely, plug in your vacuum cleaner (fig. € Set the suction power using the manual power switch on the handle: open the regulation vent in order to manually decrease the suction power, for example: on fragile surfaces – fig. Storage and transport of the appliance • After each use, switch your vacuum cleaner off by pressing on the ON/OFF pedal (2) – fig. € In the vertical position, place the nozzle (23) in its storage compartment on the appliance (1b) – fig. € In the horizontal position, place the nozzle (23) in its storage compartment on the appliance (1a) – fig. 01) suitable to paper bags Important: Replace the HEPA filter cassette* MT0007. 01* is available at your local retail store or at one of our Authorized Service Centres. € Slide the ledges of the new HEPA filter cassette* into the slots – fig. € Make sure that the HEPA filter cassette* (14a) is correctly positioned before closing the lid (8). Cleaning the hepa filter cassette* (ref : RS-RT900034), suitable for textile bags* Attention!This cleaning procedure is exclusively reserved to the HEPA filter cassette* ref: RS-RT900034. Important: Clean the HEPA filter cassette RS-RT900034 every 6 months (according to frequency of use). RS-RT900034* is available at your local retail store or at one of our Authorized Service Centres. € Make sure that the HEPA filter cassette* (14b) is perfectly dry before reinserting it. € Screw on the HEPA filter cassette* (14b) (Ref: RS-RT900034) in its compartment – fig. € Make sure that the HEPA filter cassette* (14b) is well placed before closing the lid (8). [. . . ] If the suction attachment is difficult to move • Open the regulator on the handle in order to decrease suction power. If the power cord does not wind up completely • The cord slowed down as it was winding up: pull the power cord out again and press the power cord rewind pedal. If your vacuum cleaner stops while in operation • The overheating protective device has been triggered. Check that the tube and the pipe are not blocked or that the bag or filter are not full. [. . . ]